![]() ![]() The Keypad on the X-Sight is designed to be tapped not pressed and held! When using each key on the keypad to operate the X-Sight please be aware that you need to tap each key. To turn OFF your device please press and hold the POWER button – you will see “device shutting down” with a count down, please continue to hold the POWER button throughout the entire cycle. To turn ON your device please press and hold the POWER button. When you first turn the device on after program software updating Wi-Fi > Motion Sensing Platform configuration takes place. NOTE Wi-Fi / Motion Sensing platform configuration when first turned on. NOTE If the device does not restart within 30 seconds after reaching 100%, remove and re-insert the batteries and power-up the device. Please remember to delete the Firmware File off of the microSD card after all steps are completed.Once the Firmware update completes, please do a factory reset before using the product.Motion Sensing platform will be configured when first turned on.After completing it will automatically restart and will be ready for use.Once the device is powered up it will enter self configuration mode.When the update counter reaches “100%” the device will automatically restart.In the “Firmware Update” dialog box select “Yes” to start the update.Download the ***.bin file from (You may need to create an account, if you didn’t create it earlier) and copy to your microSD Card - root directory.In the event of a power failure during an update the X-Sight may crash corrupting its system files and will need to be sent back to the ATN factory for service. ![]() NOTE You must make sure that the batteries in the X-Sight are fully charged before updating your device. NOTE Before operating your X-Sight please update the firmware to the latest version. You will also receive email announcements once a new firmware becomes available. Once you register you will be able to download the latest firmware file. To receive the notification of new firmware updates, please register your X-Sight HD by clicking REGISTER. NOTE If you are going to record video then microSD Card should be of Class 10 (10 mb/sec) or faster and have capacity from 4 to 64 Gb. When it pops up a few millimeters, it can pull with your fingers or tweezers. To remove the microSD card from the slot, push it in the same thin object. NOTE To lock when inserting microSD card in the slot, push it a thin object (a small coin, paper clip, toothpick, ballpen) until it clicks into place. A new microSD card should be formatted before using. Do not force the card into the slot as it may damage both the camera and the microSD card. NOTE There is only one correct direction to insert the microSD card. Do not over tighten as it will be difficult to remove. Make sure that the X-Sight HD is turned OFF before inserting the card into the slot.
0 Comments
Leave a Reply. |